Removing The +24 Vdc Power Supply From Cisco Asr 1002 Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

The following figure shows the +24 VDC power supply and components for the Cisco ASR 1002 Router.

Figure 284: Cisco ASR 1002 Router +24 VDC Power Supply

Removing the +24 VDC Power Supply from Cisco ASR 1002 Router

Before you can remove a +24 VDC power supply from the Cisco ASR 1002 Router, you must remove input

power going to the power supply.

Make certain that the chassis ground lead wire is connected before you begin removing and installing the

power supply.

To remove the +24 VDC power supply from the Cisco ASR 1002 Router, follow these steps:

Removing and Replacing a +24 VDC Power Supply in Cisco ASR 1002 Router

+24 VDC terminal block

Positive (+) lead

Negative (-) lead

Ground (GND) lead

Power supply LEDs

Cisco ASR 1000 Series Router Hardware Installation Guide

Standby/On switch

Captive fastener

Power supply tabs

+27 VDC INPUT label

Show Quick Links

Table of Contents