Cisco ASR 1013 Hardware Installation Manual page 536

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing the Cisco ASR1000-RP2 DIMM Memory Modules

• Back up data that you want to save before replacing a eUSB device.

• Note that the component is keyed and slotted for easier connection.

• To ensure the DIMMs are functioning properly, all four DIMMs must be replaced at the same time and

must be of the same manufacturer and part number (since vendors may have multiple versions of the

The following table shows the slots that are supported for inserting memory DIMMs in Cisco ASR1000-RP2

Table 91: Cisco ASR1000-RP2 Supported Slots for Inserting Memory DIMMs

Memory PID Option

M-ASR1K-RP2-8GB=

M-ASR1K-RP2-16GB=

This section describes how to remove and then replace the Cisco ASR1000-RP2 module DIMMs (see the

following figure).

Figure 242: Cisco ASR1000-RP2 Module Internal Component Location

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Internal hard drive

Cisco ASR1000-RP2

internal eUSB device

Show Quick Links

Table of Contents

Troubleshooting