Connecting A Cable To The Management Ethernet Port - Cisco ASR 1002-F Overview And Installation
Hide thumbs
Also See for ASR 1002-F:
- Quick start manual (39 pages) ,
- Hardware installation manual (702 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Connecting a Cable to the Management Ethernet Port
Figure 21: Cisco ASR 1002-F Router Integrated RP Console and Auxiliary Port Connectors
1
Console port
(CON)
Step 3
After you establish normal router operation, you can disconnect the console terminal.
What to do next
Note
A connection will not be established when setting up an out-of-band connection or modem connection in the
auxiliary port and the console port.
Connecting a Cable to the Management Ethernet Port
This section describes how to attach a cable to the Cisco Management Ethernet port on the Cisco ASR 1002-F
Router.
Step 1
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see ).
Figure 22: Cisco ASR 1002-F Router Integrated RP Management Ethernet Port Connector
1
Management Ethernet
port
Step 2
Insert the other end of the RJ-45 cable into your management device or network.
Step 3
Configure the port connection to a fixed speed through the command-line interface (CLI).
Cisco ASR 1002-F Router Overview and Installation
28
2
Auxiliary port
(AUX)
Cisco ASR 1002-F Router Overview and Installation
Advertisement
Table of Contents
