Removing The Dc Power Supply From Cisco Asr 1006 Router - Cisco ASR 1013 Hardware Installation Manual
Asr 1000 series
Hide thumbs
Also See for ASR 1013:
- Installation manual (42 pages) ,
- Quick start manual (37 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
5
6
*For information about
the DB-25 alarm
connector, how it works,
and Cisco ASR 1000
route processor LEDs, see
the xref "How Cisco
ASR1000-RP Alarm
Monitoring Works"
section on page 2-20.
Note: Shielded cables
must be used to connect
to the DB-25 alarm
connector on both the AC
and DC power supplies,
in order to comply with
FCC/EN55022/CISPR22
Class A emissions
requirements.
Removing the DC Power Supply from Cisco ASR 1006 Router
Before you can remove a DC power supply from the Cisco ASR 1006 Router, you must remove power from
the power supply. Follow these steps to remove power and the DC power supply from the chassis.
Make certain that the chassis ground is connected before you begin removing and installing the power
Caution
supply. For the chassis ground stud location.
Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router
Ground symbol
11
DC power supply ground
12
studs
Cisco ASR 1000 Series Router Hardware Installation Guide
Terminal block and
plastic cover slot tab
Power supply LEDs
545
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
