Table of Contents
Advertisement
IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Syntax
ipv6-address
ipv6 address
ipv6-address
no ipv6 address [
Parameters
•
ipv6-address
—Specifies the global unicast IPv6 address assigned to the
interface. This argument must be in the form documented in RFC4293
where the address is specified in hexadecimal using 16-bit values between
colons.
•
prefix-length
—The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
Default Configuration
No IP address is defined for the interface.
Command Mode
Interface Configuration mode
User Guidelines
The ipv6 address command cannot be applied to define an IPv6 address on an
ISATAP interface.
Using the no IPv6 address command without arguments removes all
manually-configured IPv6 addresses from an interface, including link local
manually configured addresses.
Example
The following example defines the IPv6 global address 2001:DB8:2222:7272::72
on vlan 100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
prefix-length
/
prefix-length
/
interface vlan 100
ipv6 address 2001:DB8:2222:7272::72/64
exit
]
28
552
Advertisement
Table of Contents
