Table of Contents
Advertisement
IPv4 IPM Router Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
27.0
27.1 ip multicast-routing
To enable IPv4 Multicast routing on all IP-enabled interfaces of the router and to
enable Multicast forwarding, use the ip multicast-routing command in global
configuration mode. To stop Multicast routing and forwarding, use the no form of
this command.
Syntax
ip multicast-routing igmp-proxy
no ip multicast-routing
Parameters
•
igmp-proxy—Enable Multicast routing using IGMP Proxy.
Default Configuration
Multicast routing is not enabled.
Command Mode
Global Configuration mode
User Guidelines
Use the ip multicast-routing command with parameter to specify the needed IP
Multicast Routing Protocol.
To forward IPv4 Multicast packets on an interface, IPv4 Multicast forwarding must
be enabled globally and an IPMv4 Routing protocol must be enabled on the
interface.
Example
The following example enables IP Multicast routing using IGMP Proxy:
27
544
Advertisement
Table of Contents
