Table of Contents
Advertisement
17
385
Example 2—The following example restarts the disabled Ethernet port.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 3—The following example shuts down vlan 100.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 4—The following example shuts down tunnel 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 5—The following example shuts down Port Channel 3.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
17.4 operation time
To control the time that the port is up, use the operation time Interface (Ethernet,
Port Channel) Configuration mode command. To cancel the time range for the port
operation time, use the no form of this command.
Syntax
time-range-name
operation time
interface gi14
no shutdown
interface vlan 100
shutdown
interface tunnel 1
shutdown
interface po3
shutdown
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Ethernet Configuration Commands
Advertisement
Table of Contents
