Table of Contents
Advertisement
9
249
Command Mode
Global Configuration mode
User Guidelines
Use the sntp broadcast client enable Interface Configuration mode command to
enable the SNTP Broadcast client on a specific interface.
After entering this command, you must enter the
sntp keyword for the command to be run. If this command is not run, the switch will
not synchronize with Broadcast servers.
Example
The following example enables SNTP Broadcast clients.
s
switchxxxxxx(config)#
9.12 sntp client enable
To enable the SNTP Broadcast and Anycast client, use the sntp client enable
command in Global Configuration mode. To restore the default configuration, use
the no form of this command.
Syntax
interface-id
sntp client enable
no sntp client enable
Parameters
•
interface-id
—Specifies an interface ID, which can be one of the following
types: Ethernet port, Port-channel or VLAN.
Default Configuration
The SNTP client is disabled.
Command Mode
Global Configuration mode
sntp broadcast client enable
interface-id
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Clock Commands
clock source
command with the
Advertisement
Table of Contents
