Ip Igmp Snooping Vlan Querier Address; Ip Igmp Snooping Vlan Querier Election - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
21.11 ip igmp snooping vlan querier address
To define the source IP address that the IGMP snooping querier uses, use the ip
igmp snooping vlan querier address command in Global Configuration mode. To
return to the default, use the no form of this command.
Syntax
ip igmp snooping vlan
no ip igmp snooping vlan
Parameters
•
vlan-id
—Specifies the VLAN.
•
ip-address
—Source IP address.
Default Configuration
If an IP address is configured for the VLAN, it is used as the source address of the
IGMP snooping querier. If there are multiple IP addresses, the minimum IP address
defined on the VLAN is used.
Command Mode
Global Configuration mode
User Guidelines
If an IP address is not configured by this command, and no IP address is
configured for the querier's VLAN, the querier is disabled.
Example
switchxxxxxx(config)# ip igmp snooping vlan 1 querier address 10.5.234.205
21.12 ip igmp snooping vlan querier election
To enable IGMP Querier election mechanism of an IGMP Snooping querier on a
specific VLAN, use the ip igmp snooping vlan querier election command in Global
Configuration mode. To disable Querier election mechanism, use the no form of
this command.
vlan-id
querier address
vlan-id
querier address
ip-address
21
442
Advertisement
Table of Contents
