Storm-Control Include-Multicast - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide
Default Configuration
10% of port speed in Kbps
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Use the storm-control broadcast enable Interface Configuration command to
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
Examples
Example 1—Set to specific level:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
Example 2—Set to specific rate:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
18.28 storm-control include-multicast
To count Multicast packets in a Broadcast storm control, use the storm-control
include-multicast Interface Configuration mode command. To disable counting of
Multicast packets in the Broadcast storm control, use the no form of this command.
Syntax
storm-control include-multicast [unknown-unicast]
no storm-control include-multicast
interface gi11
storm-control broadcast level 20
interface gi11
storm-control broadcast kbps 10000
18
416
Advertisement
Table of Contents
