Cisco 300 Series Cli Manual page 37
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
1
NOTE
IPv6z Address Conventions
37
Range lists can contain either ports and port-channels or VLANs. Combinations of
port/port-channels and VLANs are not allowed
The space after the comma is optional.
When a range list is defined, a space after the first entry and before the comma (,)
must be entered.
A sample of this command is shown in the example below:
switchxxxxxx#configure
switchxxxxxx(config)#interface range gi1-5, vlan 1-2
The following describes how to write an IPv6z address, which is a link-local IPv6
address.
The format is:
<ipv6-link-local-address>%<egress-interface>
where:
egress-interface (also known as zone) = vlan<vlan-id> | po<number> |
tunnel<number> | port<number> | 0
If the egress interface is not specified, the default interface is selected. Specifying
egress interface = 0 is equal to not defining an egress interface.
The following combinations are possible:
•
ipv6_address%egress-interface—Refers to the IPv6 address on the
interface specified.
•
ipv6_address%0—Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
ipv6_address—Refers to the IPv6 address on the single interface on which
an IPv6 address is defined.
OL-32830-01 Command Line Interface Reference Guide
Introduction
Advertisement
Table of Contents
