Ipv6 Dhcp Client Stateless - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

DHCPv6 Commands

OL-32830-01 Command Line Interface Reference Guide

• For planned changes, including renumbering. An administrator can gradually

decrease the time as the planned event nears.

• Limit the amount of time before new services or servers are available to the

client, such as the addition of a new Simple Network Time Protocol (SNTP)

server or a change of address of a Domain Name System (DNS) server.

If you configure the infinite keyword client never refreshes the information.

The following example configures an upper limit of 2 days:

switchxxxxxx(config)#

switchxxxxxx(config-if)#

14.4 ipv6 dhcp client stateless

Use the ipv6 dhcp client stateless command in Interface Configuration mode to

enable DHCP for an IPv6 client process and to enable request for stateless

configuration through the interface on which the command is run. To disable

requests for stateless configuration, use the no form of this command.

ipv6 dhcp client stateless

no ipv6 dhcp client stateless

This command has no arguments or keywords.

Default Configuration

Information request is disabled on an interface.

Command Mode

Global Configuration mode

interface vlan 100

ipv6 dhcp client stateless

ipv6 dhcp client information refresh 172800