Show Ip Arp Inspection - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
DHCP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example sets the minimum ARP SYSLOG message logging time
interval to 60 seconds.
switchxxxxxx(config)#
13.28 show ip arp inspection
Use the show ip arp inspection EXEC mode command to display the ARP
inspection configuration for all interfaces or for a specific interface.
Syntax
show ip arp inspection [
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Command Mode
User EXEC mode
Example
The following example displays the ARP inspection configuration.
switchxxxxxx#
show ip arp inspection
IP ARP inspection is Enabled
IP ARP inspection is configured on following VLANs: 1
Verification of packet header is Enabled
IP ARP inspection logging interval is: 222
Interface
Trusted
----------- -----------
gi1
1
Yes
gi1
2
Yes
ip arp inspection logging interval
interface-id
]
60
seconds
13
334
Advertisement
Table of Contents
