Removing And Replacing The Cisco Asr 1001 Router Power Supplies - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing the Cisco ASR 1001 Router Power Supplies

The following figure shows the DC power supply terminal block with cables connected.

Figure 298: Cisco ASR 1013 Router DC Power Supply Terminal Block Cable Connections

Replace the terminal block plastic cover, which is slotted and keyed to fit correctly over the terminal block; then tighten

the black screw (use the screwdriver to tighten the screw to a torque of 5 in-lbs / 1 per.).

Remove the tape from the circuit-breaker On/Off switch (if there was any).

Switch the circuit breaker On/Off switch to the On (|) position.

What to Do Next

The requirement for maximum torque applied to the power or ground Kepnuts must be 8 in-lb when the

power or ground lug is not present.

This completes the procedure for installing the DC power supply into the Cisco ASR 1013 Router.

Removing and Replacing the Cisco ASR 1001 Router Power

The Cisco ASR 1001 Router AC and DC power supplies are shipped installed in the chassis. You must connect

the power supplies when they arrive.

Cisco ASR 1000 Series Router Hardware Installation Guide

Negative lead

Positive lead

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Protective sleeving around

the stud and cable

Ground stud and cable

Show Quick Links

Table of Contents