Cisco ASR 1013 Hardware Installation Manual page 631

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

The following figure shows the DC power supply terminal block with the order of installing the screws and washers

on the ground lug.

Figure 297: Cisco ASR 1013 Router DC Power Supply Ground Lug Installation

Tighten the Kepnut screw (use the screwdriver to tighten the ground screw in the terminal block to a torque of 20+/–2

in-lbs / 2 per.) and repeat the same steps for the negative wires.

Secure the wires coming in from the terminal block so that they cannot be disturbed by casual contact.

Use tie wraps to secure the wires, so that the wires are not pulled from the terminal block by casual contact. Ti-wrap

studs are located below the power supply terminal block.

Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router

DC power supply

grounding stud with wire

Grounding screws

DC power supply ground

Cisco ASR 1000 Series Router Hardware Installation Guide

Kepnut screw

Show Quick Links

Table of Contents

Troubleshooting