Removing And Replacing A Dc Power Supply In Cisco Asr 1013 Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router

SUMMARY STEPS

1. Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.

2. Tighten the captive screws.

3. Insert the AC power cable.

4. Plug the power supply cable into the power source.

5. Turn the power supply Standby switch to the On (|) position.

DETAILED STEPS

Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.

Tighten the captive screws.

Insert the AC power cable.

Plug the power supply cable into the power source.

Turn the power supply Standby switch to the On (|) position.

What to Do Next

This completes the procedure for installing the AC power supply in the Cisco ASR 1013 Router.

Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router

This section provides information about removing and installing a DC power supply in the Cisco ASR 1013

When you install the unit, the ground connection must always be made first and disconnected last. Statement

Before performing any of the following procedures, ensure that power is removed from the DC circuit.

Statement 1003

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Show Quick Links

Table of Contents