Cisco Asr 1001 Router Faceplate Common Components - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1001 Router Faceplate Common Components

For detailed descriptions of the SPAs on which some of the IDCs are based, go to:

en/US/products/ps6267/products_data_sheets_list.html

There are two field-replaceable units in the Cisco ASR 1001 chassis. They are the DIMMs and eUSB. In

order to service the components in the chassis, you must remove the power supplies and the chassis cover.

For instructions, see the "Removing and Replacing the Cisco ASR 1001 Router DIMM Memory Modules"

and the "Remove and Replace the eUSB Device on the Cisco ASR 1001 Router" sections in the Removing

and Replacing FRUs from the Cisco ASR 1000 Series Routers chapter.

Cisco ASR 1001 Router Faceplate Common Components

The Cisco ASR 1001 Router RP faceplate has common components for each type of ASR 1001 Router

configuration. The preceding image and the following image show the Cisco ASR1000-RP faceplate with

LEDs and connectors for all configurations of the Cisco ASR 1001 Router.

Figure 202: Common Connectors for Cisco ASR 1001 Route Processor

Cisco ASR 1000 Series Router Hardware Installation Guide

USB port— one USB

high-speed (480Mbps)

port used for secure key

storage, storing of VPN

credentials, or bulk flash

storage for image and

configuration backup

LINK LED indicates

MGMT Ethernet port

Cisco ASR 1001 Router Overview and Installation

STAT—status LED

PWR—Power LED

http://www.cisco.com/

Show Quick Links

Table of Contents