Table of Contents
Advertisement
Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
no operation time
Parameters
•
time-range-name—Specifies a time range the port operates (in up state).
When the Time Range is not in effect, the port is shutdown. (Range: 1–32
characters)
Default Configuration
There is no time range configured on the port authorized state.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
It is recommended to disable spanning tree or to enable spanning-tree PortFast
mode on 802.1x edge ports (ports in auto state that are connected to end stations),
in order to proceed to the forwarding state immediately after successful
authentication.
Example
The operation time command influences the port if the port status is up. This
command defines the time frame during which the port stays up and at which time
the port will be shutdown. While the port is in shutdown because of other reasons,
this command has no effect.
The following example activates an operation time range (named "morning") on
port gi11.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
17.5 description
To add a description to an interface, use the description Interface (Ethernet, Port
Channel) Configuration mode command. To remove the description, use the no
form of this command.
interface gi11
operation time morning
17
386
Advertisement
Table of Contents
