Table of Contents
Advertisement
14
351
• For planned changes, including renumbering. An administrator can gradually
decrease the time as the planned event nears.
• Limit the amount of time before new services or servers are available to the
client, such as the addition of a new Simple Network Time Protocol (SNTP)
server or a change of address of a Domain Name System (DNS) server.
If you configure the infinite keyword client never refreshes the information.
Example
The following example configures an upper limit of 2 days:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
14.4 ipv6 dhcp client stateless
To enable DHCP for an IPv6 client process and to enable request for stateless
configuration through the interface on which the command is run, use the ipv6
dhcp client stateless command in Interface Configuration mode. To disable
requests for stateless configuration, use the no form of this command.
Syntax
ipv6 dhcp client stateless
no ipv6 dhcp client stateless
Parameters
This command has no arguments or keywords.
Default Configuration
Information request is disabled on an interface.
Command Mode
Interface Configuration mode
interface vlan 100
ipv6 dhcp client information refresh 172800
exit
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
DHCPv6 Commands
Advertisement
Table of Contents
