Table of Contents
Advertisement
1
Accessing the CLI
NOTE
31
Configuration mode. The interface Global Configuration command is used
to enter this mode.
•
Line Interface—Contains commands used to configure the management
connections for the console, Telnet and SSH. These include commands such
as line timeout settings, etc. The line Global Configuration command is used
to enter the Line Configuration command mode.
•
VLAN Database—Contains commands used to configure a VLAN as a
whole. The vlan database Global Configuration mode command is used to
enter the VLAN Database Interface Configuration mode.
•
Management Access List—Contains commands used to define
management access-lists. The management access-list Global
Configuration mode command is used to enter the Management Access
List Configuration mode.
•
MAC Access-List, IPv6 Access List, IP Access List—Configures
conditions required to allow traffic based on MAC addresses, IPv6 address
and IPv4 address, respectively. The mac access-list, ipv6 access-list and ip
access-list Global Configuration mode commands are used to enter the
these configuration mode.
To return from any Interface Configuration mode to the Global Configuration mode,
use the exit command.
The CLI can be accessed from a terminal or computer by performing one of the
following tasks:
•
Running a terminal application, such as HyperTerminal, on a computer's com
port that is directly connected to the switch's console port,
—or—
•
Running a Telnet session from a command prompt on a computer with a
network connection to the switch.
•
Using SSH from an application that supports SSH client running on a
computer with a network connection to the switch.
Telnet and SSH are disabled by default on the switch.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Introduction
Advertisement
Table of Contents
