Table of Contents
Advertisement
Clock Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
•
time-b.timefreq.bldrdoc.gov
•
time-c.timefreq.bldrdoc.gov
Command Mode
Global Configuration mode
User Guidelines
ip-address
Use the sntp server {
SNTP server. The switch supports up to 8 SNTP servers.
Use the sntp server default command to return to the default configuration.
Use the no sntp server
server.
Use the no sntp server to remove all SNTP servers.
Example
The following example configures the device to accept SNTP traffic from the
server on 192.1.1.1 with polling.
switchxxxxxx(config)#
9.15 sntp source-interface
To specify the source interface whose IPv4 address will be used as the source
IPv4 address for communication with IPv4 SNTP servers, use the sntp
source-interface command in Global Configuration mode. To restore the default
configuration, use the no form of this command.
Syntax
sntp source-interface
no sntp source-interface
Parameters
•
interface-id
—Specifies the source interface.
hostname
|
} [poll] [key
ip-address
hostname
|
192.1.1.1
sntp server
interface-id
keyid
] command to define a
command to remove one SNTP
poll
9
252
Advertisement
Table of Contents
