Ipv6 Address Eui-64 - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
27
609
Example
The following example assigns the IPv6 address automatically:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
27.4
ipv6 address eui-64
Use the ipv6 address eui-64 command in Interface Configuration mode to
configure a global unicast IPv6 address for an interface and enables IPv6
processing on the interface using an EUI-64 interface ID in the low order 64 bits of
the address. To remove the address from the interface, use the no form of this
command.
Syntax
ipv6-prefix
ipv6 address
ipv6-prefix
no ipv6 address [
Parameters
•
ipv6-address
—Specifies the global unicast IPv6 address assigned to the
interface. This argument must be in the form documented in RFC4293
where the address is specified in hexadecimal using 16-bit values between
colons.
•
prefix-length
—The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
Default Configuration
No IP address is defined for the interface.
Command Mode
Interface Configuration mode
interface vlan 100
ipv6 address autoconfig
exit
prefix-length
/
eui-64
prefix-length
/
eui-64]
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands
Advertisement
Table of Contents
