Permit (Management) - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
33
699
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with ethernet, VLAN, and port-channel parameters are valid only if an IP
address is defined on the appropriate interface.
Example
The following example denies all ports in the ACL called mlist.
switchxxxxxx(config)#
switchxxxxxx(config-macl)#
33.2 permit (Management)
To set permit rules (ACEs) for the management access list (ACL), use the permit
Management Access-list Configuration mode command.
Syntax
[interface-id] [service service]
permit
ipv4-address
permit ip-source {
prefix-length}] [interface-id] [service service]
Parameters
•
interface-id —(Optional) Specify an interface ID. The interface ID can be
one of the following types: Ethernet port, Port-channel or VLAN
•
service
service
are: Telnet, SSH, HTTP, HTTPS and SNMP.
•
ipv4-address — Specifies the source IPv4 address.
•
ipv6-address/ipv6-prefix-length — Specifies the source IPv6 address and
source IPv6 address prefix length. The prefix length must be preceded by a
forward slash (/). The parameter is optional.
•
mask
mask
— Specifies the source IPv4 address network mask. This
parameter is relevant only to IPv4 addresses.
management access-list mlist
switch deny
ipv6-address
|
— (Optional) Specifies the service type. Possible values
OL-32830-01 Command Line Interface Reference Guide
Management ACL Commands
ipv6-prefix-length
[mask {mask |
/
}
Advertisement
Table of Contents
