Table of Contents
Advertisement
47
939
Example
The following example applies the aggregate policer called Policer1 to a class
called class1 in a policy map called policy1 and class2 in policy map policy2.
switchxxxxxx(config)# qos aggregate-policer
drop
switchxxxxxx(config)# policy-map
switchxxxxxx(config-pmap)# class
switchxxxxxx(config-pmap-c)# police aggregate
switchxxxxxx(config-pmap-c)# exit
switchxxxxxx(config-pmap)# exit
switchxxxxxx(config)# policy-map
switchxxxxxx(config-pmap)# class
switchxxxxxx(config-pmap-c)# police aggregate
47.19 wrr-queue cos-map
Use the wrr-queue cos-map Global Configuration mode command to map Class of
Service (CoS) values to a specific egress queue. Use the no form of this command
to restore the default configuration.
Syntax
queue-id cos0
wrr-queue cos-map
no wrr-queue cos-map [
Parameters
•
queue-id—Specifies the queue number to which the CoS values are
mapped.
•
cos0... cos7—Specifies up to 8 CoS values to map to the specified queue
number. (Range: 0–7)
Default Configuration
The default CoS value mapping to 8 queues is as follows:
policy1
class1
policy2
class2
cos7
...
queue-id
]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Quality of Service (QoS) Commands
policer1 124000 9600
policer1
policer1
exceed-action
Advertisement
Table of Contents
