Table of Contents
Advertisement
47
935
Syntax
qos aggregate-policer
committed-burst-byte
peak-burst-byte
[violate-action
no qos aggregate-policer
Parameters
•
aggregate-policer-name
1–32 characters)
•
committed-rate-kbps
second (bps).(Range: 3–57982058)
•
committed-burst-byte
(Range: 3000–19173960)
•
exceed-action—Specifies the action taken when the committed rate is
exceeded and the peak rate is not exceeded. If the keyword is not
configured then the following action is applied:
-
drop, if peak the keyword is not configured.
-
policed-dscp-transmit, if peak the keyword is configured.
•
peak—Specifies the Two-rate Three-color policer. If the peak rate is
exceeded the packet is dropped.
•
peak-rate-kbps
(bps).(Range: 3–57982058)
•
peak-burst-byte
3000–19173960)
•
violate-action—Specifies the action taken when the peak rate is exceeded.
If the keyword is not configured then the drop action is applied.
•
action
—Specifies the taken action. The possible values are:
-
drop—Drops the packet.
-
policed-dscp-transmit—Remarks the packet DSCP of IP traffic. The
DSCP remarking is configured by the qos map policed-dscp command
with the violation keyword for the violation action and without this
keyword for the exceed action. DSCP remarking will have effect only if
the mode is trust dscp.
aggregate-policer-name committed-rate-kbps
action
[exceed-action
action
]]
aggregate-policer-name
—Specifies the aggregate policer name. (Length:
—Specifies the average traffic rate (CIR) in kbits per
—Specifies the normal burst size (CBS) in bytes.
—Specifies the average traffic rate (CIR) in kbits per second
—Specifies the peak burst size (PBS) in bytes. (Range:
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Quality of Service (QoS) Commands
peak-rate-kbps
] [peak
Advertisement
Table of Contents
