Table of Contents
Advertisement
47
927
switchxxxxxx(config-cmap)#
switchxxxxxx(config)#
switchxxxxxx(config-pmap)#
switchxxxxxx(config-pmap-c)#
47.11 set
Use the set Policy-map Class Configuration mode. command to select the value
that QoS uses as the DSCP value, the egress queue or to set user priority values.
Syntax
new-dscp
set {dscp
no set
Parameters
•
new-dscp
dscp
(Range: 0–63)
•
queue-id
queue
•
new-cos
cos
—Specifies the new user priority to be marked in the packet.
(Range: 0–7)
Command Mode
Policy-map Class Configuration mode.
User Guidelines
This command is only available when QoS is in advanced mode.
The
set
and
trust
commands are mutually exclusive within the same policy map.
To return to the Configuration mode, use the exit command. To return to the
Privileged EXEC mode, use the end command.
The queue keyword is not supported into egress policies.
exit
policy-map p1
class c1
trust
queue-id
| queue
| cos
—Specifies the new DSCP value for the classified traffic.
—Specifies the egress queue. (Range: 1-8 )
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Quality of Service (QoS) Commands
new-cos
}
Advertisement
Table of Contents
