Qos Trust (Interface); Qos Cos - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide
39.30 qos trust (Interface)
Use the qos trust Interface (Ethernet, Port Channel) Configuration mode command
to enable port trust state while the system is in the basic QoS mode. Use the no
form of this command to disable the trust state on each port.
Syntax
qos trust
no qos trust
Parameters
N/A
Default Configuration
Each port is enabled while the system is in basic mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures gi 1 1 to the default trust state.
switchxxxxxx(config)#
switchxxxxxx(config-if)# qos trust
39.31 qos cos
Use the qos cos Interface (Ethernet, Port Channel) Configuration mode command
to define the default CoS value of a port. Use the no form of this command to
restore the default configuration.
Syntax
default-cos
qos cos
no qos cos
interface gi11
39
778
Advertisement
Table of Contents
