Radius-Server Host Source-Interface - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
RADIUS Commands
OL-32830-01 Command Line Interface Reference Guide
40.4 radius-server host source-interface
Use the radius-server host source-interface Global Configuration mode command
to specify the source interface whose IPv4 address will be used as the Source
IPv4 address for communication with IPv4 RADIUS servers. Use the no form of this
command to restore the default configuration.
Syntax
radius-server host source-interface
no radius-server host source-interface
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address belonging
to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 RADIUS server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#
interface-id
radius-server host source-interface
40
vlan 100
792
Advertisement
Table of Contents
