Traffic-Shape Queue - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
39
765
switchxxxxxx(config-if)#
39.21 traffic-shape queue
Use the traffic-shape queue Interface (Ethernet) Configuration mode command to
configure the egress queue shaper. Use the no form of this command to disable
the shaper.
Syntax
queue-id committed-rate
traffic-shape queue
no traffic-shape queue
Parameters
queue-id—Specifies the queue number to which the shaper is assigned.
(Range: 1-8 ).
Note: the maximum number of queues depends on the value set in the set
system mode command.
•
committed-rate—Specifies the average traffic rate (CIR) in kbits per second
(kbps). (Range: 64 kbps–maximum port speed)
•
committed-burst—Specifies the excess burst size (CBS) in bytes. (Range:
4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The egress port shaper controls the traffic transmit rate (Tx rate) on a queue on a
port.
traffic-shape
64 4096
queue-id
OL-32830-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands
committed-burst
[
]
Advertisement
Table of Contents
