Table of Contents
Advertisement
56
1085
Packets
Interface
sampled
----------
-----------
1
30
gi1
2
30
gi1
3
30
gi1
56.7 sflow receiver source-interface
Use the sflow receiver source-interface Global Configuration mode command to
specify the source interface whose IPv4 address will be used as the Source IPv4
address for communication with sFlow receivers. Use the no form of this
command to restore the default configuration.
Syntax
sflow receiver source-interface
no sflow receiver source-interface
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address belonging
to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
Datagrams sent
to collector
--------------
50
50
50
interface-id
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
sFlow Commands
Advertisement
Table of Contents
