Table of Contents
Advertisement
sFlow Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
56.0
56.1 sflow receiver
To define the sFlow collector, use the sflow receiver Global Configuration mode
command. To remove the definition of the collector, use the no form of this
command.
Syntax
index {ipv4-address | ipv6-address | hostname} [port port]
sflow receiver
[max-datagram-size bytes]
index
no sflow receiver
Parameters
•
index—The index of the receiver. (Range: 1–8)
•
ipv4-address—IPv4 address of the host to be used as an sFlow Collector.
•
ipv6-address—IPv6 address of the host to be used as an sFlow Collector.
When the IPv6 address is a Link Local address (IPv6Z address), the
outgoing interface name must be specified. Refer to the User Guidelines for
the interface name syntax.
•
hostname—Hostname of the host to be used as an sFlow Collector. port—
(Optional) Port number for sflow messages. If unspecified, the port number
defaults to 6343. The range is 1-65535.
•
bytes—(Optional) Specifies the maximum datagramsize that can be sent. If
unspecified, it defaults to 1400.
Default
No receiver is defined.
56
1080
Advertisement
Table of Contents
