Table of Contents
Advertisement
Smartport Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Default Configuration
By default, auto detection of ip_phone, ip_phone_desktop, switch, and wireless
access point (ap) is enabled.
Command Mode
Global Configuration mode
Example
In this example, automatic detection of wireless access points (ap) is enabled.
switchxxxxxx(config)#
host
ip_phone
ip_phone_desktop
switch
router
ap
switchxxxxxx(config)#
55.7 macro auto resume
The macro auto resume Interface Configuration mode command changes the
Smartport type from unknown to default and resumes the Smartport feature on a
given interface (but does not reapply the Smartport macro; this is done by the
macro auto trunk refresh command).
Syntax
macro auto resume
Parameters
This command has no parameters or keywords.
macro auto processing type ?
set type to host
set type to ip_phone
set type to ip_phone_desktop
set type to switch
set type to router
set type to access point
macro auto processing type ap enabled
55
1066
Advertisement
Table of Contents
