Snmp-Server Group - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Network Management Protocol (SNMP) Commands

OL-32830-01 Command Line Interface Reference Guide

45.7 snmp-server group

To configure an SNMP group, use the snmp-server group Global Configuration

mode command. Groups are used to map SNMP users to SNMP views. To remove

an SNMP group, use the no form of this command.

snmp-server group

[read readview] [write writeview]

no snmp-server group

v1—Specifies the SNMP Version 1 security model.

v2—Specifies the SNMP Version 2 security model.

v3—Specifies the SNMP Version 3 security model.

noauth—Specifies that no packet authentication will be performed.

Applicable only to the SNMP version 3 security model.

auth—Specifies that packet authentication without encryption will be

performed. Applicable only to the SNMP version 3 security model.

priv—Specifies that packet authentication with encryption will be

performed. Applicable only to the SNMP version 3 security model. Note that

creation of SNMPv3 users with both authentication and privacy must be

done in the GUI. All other users may be created in the CLI.

generating informs or a traps. An inform is a trap that requires

acknowledgement. Applicable only to the SNMP version 3 security model.

(Length: 1–30 characters)

only. (Length: 1–30 characters)

configuring the agent. (Length: 1–30 characters)

Default Configuration

No group entry exists.

v1 | v2 | v3 {noauth | auth | priv} [notify notifyview]}

groupname {v1 | v2 | v3 [noauth | auth | priv]}

—Specifies the group name. (Length: 1–30 characters)

—(Optional) Specifies the view name that enables

—(Optional) Specifies the view name that enables viewing

—(Optional) Specifies the view name that enables