Cisco 300 Series Cli Manual page 859

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

prefix-length—(Optional) Specifies the number of bits that comprise the

IPv4 address prefix. If unspecified, it defaults to 32. The command returns

an error if the prefix-length is specified without an IPv4 address.

configurations is imposed on the user). The view defines the objects

available to the community. It is not relevant for su, which has access to the

whole MIB. If unspecified, all the objects, except the community-table and

SNMPv3 user and access tables , are available. (Range: 1–30 characters)

Default Configuration

No community is defined

Command Mode

Global Configuration mode

User Guidelines

The logical key of the command is the pair (community, ip-address). If ip-address

is omitted, the key is (community, All-IPs). This means that there cannot be two

commands with the same community, ip address pair.

is used to restrict the access rights of a community string. When a

view-name is specified, the software:

Generates an internal security-name.

Maps the internal security-name for SNMPv1 and SNMPv2 security models

to an internal group-name.

Maps the internal group-name for SNMPv1 and SNMPv2 security models to

view-name (read-view and notify-view always, and for rw for write-view

Defines a password for administrator access to the management station at IP

address 1.1.1.121 and mask 255.0.0.0.

switchxxxxxx(config)#

Network Management Protocol (SNMP) Commands

—(Optional) Specifies the name of a view configured using

snmp-server view

(no specific order of the command

snmp-server community abcd su 1.1.1.121 mask 255.0.0.0

OL-32830-01 Command Line Interface Reference Guide