Example: Setting Up A Backend Server - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuring the Device
Example: Setting up a Backend Server
Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-10
6.
Save the configuration to flash memory. If it is not saved, the configuration is
lost during a power cycle or if the reload command when used.
SCA# write flash
SCA#
You can review the configuration of the currently edited
Note
SSL object (key, certificate, certificate chain, security
policy, or server) by using the info command in the
appropriate mode.
This example describes how to use the configuration manager to set up a
backend server.
Enter Privileged, Configuration, and SSL Configuration modes.
1.
SCA> enable
SCA# configure
(config[myDevice])# ssl
(config-ssl[myDevice])#
Enter Backend Server Configuration mode and create a backend server named
2.
myBackServ.
(config-ssl[myDevice])# backend-server myBackServ create
(config-ssl-backend[myBackServ])#
3.
Assign an IP address and netmask to the backend server.
(config-ssl-backend[myBackServ])# ip address
4.
Assign port 443 for SSL traffic and port 80 for clear text traffic.
(config-ssl-backend[myBackServ])# localport 80
(config-ssl-backend[myBackServ])# remoteport 443
5.
Specify a security policy for the server.
(config-ssl-backend[myBackServ])# secpolicy strong
Chapter 4
Using the Configuration Manager
78-13124-05
Advertisement
Table of Contents
Troubleshooting
