Initiating A Management Session; Serial Management And Ip Address Assignment - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 4
Using the Configuration Manager
Initiating a Management Session
Note
Serial Management and IP Address Assignment
Note
78-13124-05
Use the appropriate instructions below to initiate a management session with the
Secure Content Accelerator.
When using the Secure Content Accelerator in FIPS Mode, only
serial management is allowed.
Follow these steps to initiate a management session via a serial connection and set
an IP address for the device.
The default terminal settings on the SSL devices and modules is 80
columns by 25 lines. To ensure the best display and reduce the
chance of graphic anomalies, please use the same settings with the
serial terminal software. The device terminal settings can be
changed, if necessary. Use the standard ANSI setting on the serial
terminal software.
1.
Attach the included null modem cable to the appliance port marked
"CONSOLE". Attach the other end of the null modem cable to a serial port
on the configuring computer.
Launch any terminal emulation application that communicates with the serial
2.
port connected to the appliance. Use these settings: 9600 baud, 8 data bits, no
parity, 1 stop bit, no flow control.
3.
Press Return. Initial information is displayed followed by an
Enter Privileged and Configuration modes and set the IP address using the
4.
following commands. Replace the IP address in the example with the
appropriate one.
SCA> enable
SCA# configure
(config[SCA])# ip address 10.1.2.5 netmask 255.255.255.0
(config[SCA])#
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Initiating a Management Session
prompt.
SCA>
4-5
Advertisement
Table of Contents
Troubleshooting
