Example: Configuring Secure Url Rewrite - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuring the Device
Note
Example: Configuring Secure URL Rewrite
Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-12
5.
Exit to Privileged mode and save the configuration to flash memory. If it is
not saved, the configuration is lost during a power cycle or when the reload
command is used.
(config-ssl-rproxy[myRevServ])# finished
SCA# write flash
SCA#
When using this configuration, client browsers must be set to use
this device as a proxy.
The Secure URL Rewrite feature prevents URL redirects and references from
breaking or circumventing SSL sessions. This example uses the CLI. The same
options are available in the GUI.
Open a management session with the device.
1.
Enter Privileged, Configuration, and SSL Configuration modes:
2.
SCA> enable
SCA# configure
(config[SCA])# ssl
(config-ssl[SCA])#
Enter Server Configuration mode for the server you wish to configure URL
3.
rewrites.
(config-ssl[SCA])# server myServer
(config-ssl-server[myServer])#
4.
The urlrewrite command uses the following syntax:
urlrewrite < domainName > [sslport < portid >] [clearport < portid >]
<redirectonly>
Chapter 4
Using the Configuration Manager
78-13124-05
Advertisement
Table of Contents
Troubleshooting
