Figure 5-33 Add Http Headers Example; Figure 5-34 Add Keepalives Example - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
SSL Configuration Examples
26.
Figure 5-33 Add HTTP Headers Example
27.
Figure 5-34 Add Keepalives Example
28.
The same procedures are used to create and edit backend servers and
reverse-proxy servers. Options presented in the window change, depending upon
the type of server being configured.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
5-34
Make desired changes to the Add HTTP Headers to backend HTTP
Stream panel. This area is shown in Figure 5-33.
You can enable and configure keepalive "GET" messages between the virtual
servers on the device and hardware servers to which they refer. If no response
is received from the hardware server after set amount of time (maxfailure),
the virtual server is marked as "suspended". This information is configured
in the Backend Server Keep-Alive panel as shown in Figure 5-34
Click OK to create the secure server on the Secure Content Accelerator.
Chapter 5
Graphical User Interface Reference
78-13124-05
Advertisement
Table of Contents
Troubleshooting
