Snmp Trap-Host - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
snmp trap-host
Syntax Description
Usage Guidelines
Related Commands
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-80
Assigns a destination for SNMP trap messages.
snmp trap-host <v1|v2c> <ipaddr> [community]
no snmp trap-host <v1|v2c> <ipaddr> [community]
v1
v2c
ipaddr
community
Availability: Serial, Telnet; FIPS Mode (serial only)
no snmp (Configuration Command Set)
show snmp (Non-Privileged Command Set)
snmp access-list (Configuration Command Set)
snmp contact (Configuration Command Set)
snmp default community (Configuration Command Set)
snmp enable (Configuration Command Set)
snmp location (Configuration Command Set)
snmp trap-type enterprise (Configuration Command Set)
snmp trap-type generic (Configuration Command Set)
Specifies SNMP version 1.
Specifies SNMP version 2c.
The IP address of the computer receiving the
messages.
The SNMP community. If a community is specified
with the snmp default community command, you do
not need to specify a community with this command.
If you wish trap messages to be sent to a community
other than the default community, you must specify a
community when giving this command. The
community must be entered within quotation marks.
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
