Snmp Enable - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
Syntax Description
Usage Guidelines
Related Commands
snmp enable
Usage Guidelines
Note
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-78
comName
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to clear the community name.
no snmp (Configuration Command Set)
show snmp (Non-Privileged Command Set)
snmp access-list (Configuration Command Set)
snmp contact (Configuration Command Set)
snmp enable (Configuration Command Set)
snmp location (Configuration Command Set)
snmp trap-host (Configuration Command Set)
snmp trap-type enterprise (Configuration Command Set)
snmp trap-type generic (Configuration Command Set)
Enables SNMP using the current SNMP configuration.
snmp enable
no snmp enable
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to disable SNMP without clearing SNMP data.
The device must be rebooted (reloaded) before this command takes
effect.
The string containing the community name. The string
may contain up to 60 characters with no spaces. This
information is entered within quotes.
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
