Snmp Trap-Type Generic - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
Related Commands
snmp trap-type generic
Usage Guidelines
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-82
(This command must be entered on one line.) Use the no form of the command to
disable the specified event trap-type. The table below shows trap-type minimum,
maximum, and default levels for each value argument. Except in the case of
cpu-utilization, the levels indicate actual values; cpu-utilization levels indicate
percentage of use.
Trap-Type
cpu-utilization
ssl-tps
ssl-total-connections 1
no snmp (Configuration Command Set)
show snmp (Top Level Command Set)
snmp access-list (Configuration Command Set)
snmp contact (Configuration Command Set)
snmp default community (Configuration Command Set)
snmp enable (Configuration Command Set)
snmp location (Configuration Command Set)
snmp trap-host (Configuration Command Set)
snmp trap-type generic (Configuration Command Set)
Enables generic SNMP traps.
snmp trap-type generic
no snmp trap-type generic
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to disable generic SNMP traps.
Value1
Value1
Value1
Min
Max
Default
1
99
75
1
2500
170
10000
600
Appendix C
Command Summary
Value2
Value2
Value2
Min
Max
Default
1
99
90
1
2500
190
1
10000
800
78-13124-05
Advertisement
Table of Contents
Troubleshooting
