Example: Configuring Sntp Servers - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuring the Device
Example: Configuring SNTP Servers
Note
Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-14
Wildcards should be used with care to avoid any unwanted rewriting of
references.
6.
To see the results of these URL rewrite rules in the server configuration, enter
the following command. The results are presented below it.
(config-ssl-server[myServer])# show ssl server myServer
...
URL Rewrite:
Name
__________________________________________________________________
www.mybusiness1.com
www.mybusiness2.com
*.mybusiness3.com
For more information about URL rewriting, contact your Cisco representative for
a copy of the white paper SSL Offloaders and Contextual Consistency.
Up to four SNTP servers can be configured on the Secure Content Accelerator.
To provide increased security, we recommend using an SNTP server
on the internal network. Using an external SNTP server might
compromise network security.
Open a management session with the device.
1.
2.
Enter Privileged and Configuration modes:
SCA> enable
SCA# configure
(config[SCA])#
3.
Enter the IP addresses or host names of up to four SNTP servers. (Host names
are resolved to IP addresses in the device configuration.)
(config[SCA])# sntp server 10.1.24.2
(config[SCA])# sntp server 10.1.24.4
(config[SCA])# sntp server 10.2.22.2
(config[SCA])# sntp server 10.2.22.6
(config[SCA])#
Chapter 4
Using the Configuration Manager
Clear Port
SSL Port
443
81
443
81
443
81
Redirect Only
No
Yes
No
78-13124-05
Advertisement
Table of Contents
Troubleshooting
