Keepalive Enable; Keepalive Frequency - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Appendix C
Command Summary
Usage Guidelines
keepalive enable
Usage Guidelines
Related Commands
keepalive frequency
Syntax Description
Usage Guidelines
Related Commands
78-13124-05
Availability: Serial, Telnet; FIPS Mode (serial only)
Using the no form of the command clears the IP address for the backend server.
Allows keepalive messages to be sent to the hardware server corresponding to the
current virtual backend server.
keepalive enable
no keepalive enable
Availability: Serial, Telnet; FIPS Mode (serial only)
Using the no form of the command disables sending of keepalive messages.
keepalive frequency(Backend Server Configuration Command Set)
keepalive maxfailure (Backend Server Configuration Command Set)
Specifies the interval between keepalive messages.
keepalive frequency <seconds>
seconds
Availability: Serial, Telnet; FIPS Mode (serial only)
keepalive enable (Backend Server Configuration Command Set)
keepalive maxfailure (Backend Server Configuration Command Set)
Cisco 11000 Series Secure Content Accelerator Configuration Guide
The number of seconds between keepalive messages;
the range is 1 to 255 seconds (inclusive); the default is
5 seconds
Configuration Command Set
C-107
Advertisement
Table of Contents
Troubleshooting
