Sntp Server; Ssl - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
sntp server
Syntax Description
Usage Guidelines
Related Commands
ssl
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-84
Assigns an SNTP server.
sntp server <ipaddr>
no sntp server <ipaddr>
ipaddr
Availability: Serial, Telnet; FIPS Mode (serial only)
You are prompted to enter and verify the password. Use the no form of the
command to clear the SNTP server. If more than one SNTP server has been
configured, you must specify the IP address or hostname of the one to delete. Up
to four SNTP servers can be configured. If the first SNTP server returns an error,
the next SNTP server is polled. After the fourth SNTP poll returns an error, the
first server is polled again. SNTP information can be displayed using the
commands show device, show sntp and write terminal.
Note
When a hostname is used rather than an IP address, the hostname is
resolved as an IP address when written to the configuration.
show device (Non-Privileged Command Set)
show sntp (Non-Privileged Command Set)
sntp interval (Configuration Command Set)
write terminal (Privileged Command Set)
Enters SSL Configuration mode for the current device.
ssl
The IP address of the SNTP server.
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
