Tcp-Tuning; Tlsv1 Enable - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Appendix C
Command Summary
Related Commands
tcp-tuning
Usage Guidelines
Related Commands
tlsv1 enable
Usage Guidelines
Related Commands
78-13124-05
•
If you are editing an existing reverse-proxy server and you use the suspend
now command, all connections are suspended. When the end command is
entered, the current reverse-proxy server is removed, and a new suspended
reverse-proxy server is created.
activate (Reverse-Proxy Server Configuration Mode)
Enters TCP Tuning Configuration mode at for this server.
tcp-tuning
Availability: Serial, Telnet; FIPS Mode (serial only)
See the section "TCP Tuning Configuration Command Set".
Enables TLS version 1 protocols.
tlsv1 enable
no tlsv1 enable
Availability: Serial, Telnet
Using the no form of the command disables TLS version 1 protocols. You cannot
disable SSL version 2 and 3 and TLS protocols. The command no tlsv1 enable is
not available in FIPS mode.
sslv2 enable(Reverse-Proxy Server Configuration Command Set)
sslv3 enable (Reverse-Proxy Server Configuration Command Set)
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Configuration Command Set
C-139
Advertisement
Table of Contents
Troubleshooting
