Rto-Max - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
Syntax Description
Usage Guidelines
Related Commands
rto-max
Syntax Description
Usage Guidelines
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-178
milliseconds
default
Availability: Serial, Telnet; FIPS Mode (serial only)
The retransmission timer is designed to ensure data delivery in the absence of an
acknowledgment from the data receiver. The default value is used when no round
trip time (rtt) has yet been computed. Use the no form of the command to return
the rto-def to the global value. If no global settings exist for a parameter, the
factory default parameter is used instead. See RFC 1122 and RFC 2988.
rto-max (TCP Tuning Configuration Command Set)
rto-min (TCP Tuning Configuration Command Set)
Specifies the maximum allowable roundtrip timeout (rto) value.
rto-max <milliseconds|default>
no rto-max
milliseconds
default
Availability: Serial, Telnet; FIPS Mode (serial only)
The default number of milliseconds before
retransmitting; the valid range is from 500 to 30000
milliseconds (inclusive).
The factory default. At the time of publication, the
factory default is 3000 milliseconds.
The default number of milliseconds before
retransmitting; the valid range is from the rto-def
value to 65535 milliseconds (inclusive).
The factory default. At the time of publication, the
factory default is 64000 milliseconds.
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
