Table of Contents
Advertisement
Cisco Remote PHY Shelf 7200 Management Guide for Cisco Remote PHY Shelf 7200 Software 1.x
You must enable-notifications for the RPD to report any event to the Core.
Applying the Event Profile to RPD
Use the following commands to apply the Event Profile to an RPD:
enable
configure terminal
cable rpd rpd_name
rpd-event profile profile_id
Note
If RPD is online when changing the profile, reset the RPD, after you change the profile.
Enable RPD Event Trap
You can enable RPD event traps to send RPD events using SNMP traps. Use the following commands to
configure RPD event traps:
enable
configure terminal
snmp-server enable traps rpd-event priority
Priority can be 1-8, where:
• 1—Enable RPD event trap for emergency priority
• 2— Enable RPD event trap for alert priority
• 3—Enable RPD event trap for critical priority
• 4— Enable RPD event trap for error priority
• 5— Enable RPD event trap for warning priority
• 6— Enable RPD event trap for notice priority
• 7— Enable RPD event trap for informational priority
• 8— Enable RPD event trap for debug priority
The priority higher than the selected priority is also displayed.
Configure SNMP Trap Server
You can configure SNMP trap server on the cable modem using the following commands:
enable
cnfigure terminal
Router# snmp-server host ip_address traps version 2c public udp-port port_number
where,
• ip_address—IP address of the server
• port_number—UDP port number assigned to receive the SNMP traps. The same port number must also
be configured on the SNMP server.
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Applying the Event Profile to RPD
97
Advertisement
Table of Contents
