Table of Contents
Advertisement
Restrictions for Configuring Controller Profile and RPD
• All channels within the profiles of an RPD must be unique. Frequencies must not overlap each other.
• The principal core must contain at least one DOCSIS downstream profile
• Auxiliary core should contain only video and out-of-band profiles
• A DS controller can be associated to only one profile
Restrictions for Configuring Controller Profile and RPD
The following restrictions are applicable to configuring upstream controller profiles:
• Legacy controller configuration commands are not supported
• Legacy controller configuration cannot be shown in running-configuration
Configure Controller Profile and RPD
Note
To know more about the commands referenced in this module, see the
Configure Upstream Controller Profile
To configure the upstream controller-profile, use the cable upstream controller-profile command, as given in
the following example:
cable upstream controller-profile 0
cable def-phy-burst 0
us-channel 0 chan-class-id 0
us-channel 0 channel-width 1600000 1600000
us-channel 0 docsis-mode atdma
us-channel 0 equalization-coefficient
us-channel 0 frequency 50000000
us-channel 0 hop-priority frequency modulation channel-width
us-channel 0 ingress-noise-cancellation 100
us-channel 0 maintain-psd
us-channel 0 max-logical-chans 1
us-channel 0 minislot-size 4
us-channel 0 modulation-profile 221
us-channel 0 power-level 0
us-channel 0 rng-holdoff 0
no us-channel 0 shutdown
us-channel 0 specsvl error-adaptive-profile 1
us-channel 0 threshold cnr-profiles 25 13
us-channel 0 threshold corr-fec 3
us-channel 0 threshold hysteresis 3
us-channel 0 threshold snr-profiles 25 13
us-channel 0 threshold uncorr-fec 1
...
end
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
58
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Cisco IOS Master Command
List.
Advertisement
Table of Contents
