Table of Contents
Advertisement
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
• Share cBR-8 capacity across multiple hubs
• Fewer RPHY cores required
• Increased cBR-8 scale (ports/SG)
• Higher core license utilization
Cisco cBR-8 Line Card for Remote PHY
Cisco cBR-8 router supports following line card for the Remote PHY system.
Cisco CCAP RF Line Card for Remote PHY
The Cisco CCAP RF line card for remote PHY architecture is available in two flavours:
• CBR-LC-8D31-16U30—This RF line card with the downstream and upstream PHY modules can be
• CBR-CCAP-LC-40G-R—This RF line card with no downstream and upstream PHY modules can be
Cisco Digital Physical Interface Card
The Cisco Digital Physical Interface Card (DPIC) transmits and receives RF signals between the subscriber
and headend over the hybrid fiber-coaxial (HFC) system and is DOCSIS-compliant. This interface card is
designed specifically for the Cisco cBR router. The PID is cBR-DPIC-8X10G. For more information, see
Cisco cBR Series 8x10G Remote PHY Digital Physical Interface Card Data
The DPIC is installed in the CMTS and connected to the Cisco GS7000 node via the EPON, GPON, or Metro
Ethernet. It supports both downstream and upstream traffic. Both the downstream and upstream traffic share
the same ports.
connected with the Cisco GS7000 node by configuring it using the card cBR-CCAP-LC-40G r-phy
command.
connected with the Cisco GS7000 node and Remote PHY Shelf 7200. For more information, see
cBR Series Converged Cable Access Platform 40G Remote PHY Line Card Data Sheet
.
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Cisco cBR-8 Line Card for Remote PHY
Sheet.
Cisco
3
Advertisement
Table of Contents
