Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cisco Secure Network Server 3700 Series
Summary of Contents for Cisco Secure Network Server 3700 Series
- Page 1 Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide Americas Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 http://www.cisco.com Tel: 408 526-4000 800 553-NETS (6387) Fax: 408 527-0883...
- Page 2 Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: https://www.cisco.com/c/en/us/about/legal/trademarks.html.
-
Page 3: Table Of Contents
Setting Up the System With the Cisco IMC Configuration Utility Updating the BIOS and Cisco IMC Firmware Accessing the System BIOS Smart Access Serial C H A P T E R 3 Server Specifications Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... - Page 4 Contents Server Specifications Physical Specifications Environmental Specifications Power Specifications 1050 W V2 DC Power Supply 1050 W AC Power Supply Power Cord Specifications Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 5: Cisco Secure Network Server 3700 Series Appliance Overview
The Cisco Secure Network Server (SNS) 3700 series appliances are based on the Cisco Unified Computing System (Cisco UCS) C220 Rack Server and are configured specifically to support Cisco ISE. Cisco SNS 3700 series appliances are designed to deliver high performance and efficiency for a wide range of workloads. -
Page 6: Cisco Sns 3700 Series Appliance Hardware Specifications
Cisco SNS 3700 Series Appliance Hardware Specifications Cisco SNS 3700 Series Appliance Hardware Specifications The following table describes the hardware specifications of Cisco SNS 3700 series appliances. Table 1: Cisco SNS 3700 Series Appliance Hardware Specifications Cisco SNS 3700 Series Appliance... -
Page 7: External Features
Server Specifications, on page Note • You cannot add additional hardware resources like memory, processor, or hard disk to a Cisco SNS 3700 series appliance. • Mixing SAS/SATA hard drives and SAS/SATA SSDs is not supported. You must use either SAS/SATA hard drives or SAS/SATA SSDs. - Page 8 ¾ length, x16 lanes PCIe card and is controlled by CPU 1. • three half-height, ¾ length risers. • Full-height risers: Two full height, ¾ length risers. Note For definitions of LED states, see Rear-Panel LEDs, on page Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 9: Status Leds And Buttons
Cisco Secure Network Server 3700 Series Appliance Overview Status LEDs and Buttons Figure 2: Cisco SNS 3700 Series Appliance Rear Panel, Full Height, ¾ Length PCIe Cards PCIe slots Power supply units (PSUs), which can be redundant when configured in 1+1 power mode. -
Page 10: Front-Panel Leds
Cisco Secure Network Server 3700 Series Appliance Overview Front-Panel LEDs Front-Panel LEDs The following figure shows the front panel LEDs of Cisco SNS 3700 series appliance. Figure 3: Front Panel LEDs Table 2: Front Panel LEDs LED Name States • Off: There is no AC power to the server. - Page 11 • Green: The server is operating at normal temperature. Temperature status ( ) • Amber, steady: One or more temperature sensors breached the critical threshold. • Amber, blinking: One or more temperature sensors breached the non-recoverable threshold. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 12: Rear-Panel Leds
Cisco Secure Network Server 3700 Series Appliance Overview Rear-Panel LEDs Rear-Panel LEDs The following figure shows the rear panel LEDs of Cisco SNS 3700 series appliance. Figure 4: Rear Panel LEDs Table 3: Rear Panel LEDs LED Name States 1-Gb or 10-Gb Ethernet link speed (on both •... -
Page 13: Internal Diagnostic Leds
• Green, blinking: Traffic is present on the active link. COM port (RJ-45 connector) — VGA display port (DB15 connector) — Internal Diagnostic LEDs The server has internal fault LEDs for CPUs, DIMMs, and fan modules. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 14: Serviceable Component Locations
• Off: CPU is OK. Serviceable Component Locations This section describes the field-replaceable components and service related items. The view in the following figure shows the appliance with the top cover removed. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... - Page 15 Cisco Secure Network Server 3700 Series Appliance Overview Serviceable Component Locations Figure 6: Cisco SNS 3700 Series Appliance, Full Height, Full Width PCIe Cards, Serviceable Component Locations Front-loading drive bays 1–10 support M6 modular RAID card or SATA Interposer SAS/SATA drives...
-
Page 16: Summary Of Server Features
Baseboard management BMC, running Cisco IMC firmware. Depending on your Cisco IMC settings, Cisco IMC can be accessed through the 1-Gb dedicated management port, the 1-Gb/10-Gb Ethernet LAN ports, or a Cisco virtual interface card. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... - Page 17 One dedicated socket (x16 PCIe lane) that can be used to add an mLOM card for additional rear-panel connectivity. As an optional hardware configuration, the Cisco CNIC mLOM module supports two 100G QSFP+ ports or four 25 Gbps Ethernet ports.
- Page 18 Integrated Management Processor Baseboard Management Controller (BMC) running Cisco IMC firmware. Depending on your Cisco IMC settings, the Cisco IMC can be accessed through the 1GE dedicated management port, the 1GE/10GE LOM ports, or a Cisco virtual interface card (VIC).
- Page 19 Description Storage Controllers The SATA Interposer board, Cisco 12G SAS RAID Controller with 4GB FBWC, or Cisco 12G SAS Host Bus Adapter (HBA). Only one of these can be used at a time . A Cisco 9500-8e 12G SAS HBA can be plugged into available PCIe risers for connecting external JBOD.
- Page 20 Cisco Secure Network Server 3700 Series Appliance Overview Summary of Server Features Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 21: Installing The Appliance
Installing the Appliance in a Rack, on page 19 • Initial Setup, on page 23 • Setting Up the System With the Cisco IMC Configuration Utility, on page 26 • Updating the BIOS and Cisco IMC Firmware, on page 28 •... -
Page 22: Rack Requirements
• The rack-post holes can be square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), #12-24 UNC, or #10-32 UNC when you use the Cisco-supplied slide rails. • The minimum vertical rack space per server must be one rack unit (RU), equal to 1.75 inch (44.45 mm). Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 23: Installing The Appliance In A Rack
• The total length of the server including the CMA is 35.2 inches (894 mm). Installing the Appliance in a Rack This section describes how to install the appliance in a rack using the supported rail kit that is sold by Cisco. Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. - Page 24 This appliance can weigh up to 60 pounds (27 kilograms) when fully loaded with components. We recommend that you use a minimum of two people or a mechanical lift when lifting the appliance. Attempting this procedure alone could result in personal injury or equipment damage. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
- Page 25 (Optional) If applicable, do the following: a) Attach the cable management arm. See Installing the Cable Management Arm (Optional), on page 22 Reversing the Cable Management Arm (Optional), on page b) Attach the locking bezel. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 26: Installing The Cable Management Arm (Optional)
Step 3 Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your rack. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 27: Reversing The Cable Management Arm (Optional)
Figure 11: Reversing the CMA CMA tab on end of width-adjustment Metal button on outside of tab slider Initial Setup Note This section describes how to connect to the system for initial setup. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 28: Connecting To The Appliance Locally For Setup
(VIC) to access the Cisco Integrated Management Interface (Cisco IMC). If you want to use the 10/100/1000 dedicated management ports to access Cisco IMC, you can connect to the appliance and change the NIC mode as described in... -
Page 29: Connecting To The Appliance Remotely For Setup
This server node has a range of six MAC addresses assigned to the Cisco IMC. The MAC address printed on the label is the beginning of the range of six contiguous MAC addresses. -
Page 30: Setting Up The System With The Cisco Imc Configuration Utility
Step 8 When prompted, press F8 to enter the Cisco IMC Configuration Utility. When you open the Cisco IMC Configuration Utility for the first time, you are prompted to change the default Note password. The default password is password. The Strong Password feature is enabled. - Page 31 Active-Active or Active-standby NIC redundancy setting in the following step. • VIC Slot: Only if you use the Cisco Card NIC mode, you must select this setting to match where your VIC is installed. You can select Riser1, Riser2, or Flex-LOM (the mLOM slot).
-
Page 32: Updating The Bios And Cisco Imc Firmware
The server uses firmware obtained from and certified by Cisco. Cisco provides release notes with each firmware image. You can upgrade the Cisco IMC and BIOS firmware by using the Cisco IMC GUI or CLI interface. Accessing the System BIOS Step 1 Enter the BIOS Setup Utility by pressing the F2 key when prompted during bootup. -
Page 33: Smart Access Serial
• To switch from Cisco IMC CLI to host serial, press Esc+8. Note You cannot switch to Cisco IMC CLI if the serial-over-LAN (SOL) feature is enabled. • After a session is created, it is shown in the CLI or web GUI by the name... - Page 34 Installing the Appliance Smart Access Serial Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
-
Page 35: Server Specifications
Server with slide rail: 31.5 in (800.1 mm) Weight • Maximum: 42.432 lb (19.25 kg) • Minimum: 22.32 lb (10.13 kg) Environmental Specifications The following table lists the environmental requirements and specifications for the server. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 36: Power Specifications
Do not mix power supply types or wattages in the server. Both power supplies must be identical. The power specifications for the supported power supply options are listed in the following sections. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 37: 1050 W V2 Dc Power Supply
100% load, during input voltage dropout. 1050 W AC Power Supply This section lists the specifications for each 1050 W AC power supply. Parameter Specification Input Connector IEC320 C14 Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... -
Page 38: Power Cord Specifications
The shorter jumper power cords, for use in racks, are available as an optional alternative to the standard power cords. Note Only the approved power cords or jumper power cords listed below are supported. Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide... - Page 39 AC power cord, 250 V, 10 A, C13 EL302 Taiwan CAB-C13-CBN 0.68 AC cabinet jumper power cord, 250 V, 10 A, C13 to C14 CAB-C13-C14-2M AC cabinet jumper power cord, 250 V, 10 A, C13 to C14 Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
- Page 40 AC power cord, 250 V, 10 A, CEI 23-16/VII plug Italy CAB-C13-C14-3M-IN AC power cord jumper, C13 to C14 connector India CAB-C13-C14-IN AC power cord jumper, C13 to C14 connector India Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
- Page 41 Power Cord, 125 V AC, 13 A, KSC8305 plug Korea CAB-JPN-3PIN — 90-125 V AC, 12 A, NEMA 5-15 plug Japan R2XX-DMYMPWRCORD No power cord; PID option for ordering server with no power cord Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...
- Page 42 Server Specifications Power Cord Specifications Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide...